Question On 73-87 Brake Conversion - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Ole Blue 68 · 04-03-2007, 05:05 PM

I picked up a 75 front end this weekend for converting my 68 over to disc and I was wondering which way to go about it. I could bolt in the whole subframe or I could just use the spindles and change out the ball joints and tie rods.

Whose done this switch and which route did you go?

I read somewhere that if you bolt in the whole subframe, it'll cause your wheels to stick out about an inch wider than the rears. Anybody else hear that?

04-03-2007, 05:05 PM	#1
Ole Blue 68 Registered User Join Date: Aug 2005 Location: Philly Posts: 1,140	Question On 73-87 Brake Conversion I picked up a 75 front end this weekend for converting my 68 over to disc and I was wondering which way to go about it. I could bolt in the whole subframe or I could just use the spindles and change out the ball joints and tie rods. Whose done this switch and which route did you go? I read somewhere that if you bolt in the whole subframe, it'll cause your wheels to stick out about an inch wider than the rears. Anybody else hear that?



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.