|
04-18-2007, 07:34 PM
|
#1 |
|
Senior Member
Join Date: May 2004
Location: johnstown, NY
Posts: 2,393
|
What did I screw up??
I was welding on my lower control arm today. Before I started, the crossshaft turned freely. After I finished welding, I froze it up. I can barely turn it with a pair of pipe plyers. I thought maybe it temporarily expanded by the heat, but after it cooled down, I still cant move it. What happened? Should I replace the whole shaft or can I just replace the bushings?
josh |
|
|
| Bookmarks |
|
|
Threaded Mode