Front end tear down Rebuild progress! - The 1947 - Present Chevrolet & GMC Truck Message Board Network

ChevyDude · 05-01-2007, 11:37 AM

My newly acquired 71' disc front end was 35+ plus years dirty, of course and has now been completely taken apart and is soaking in Oven cleaner...again. I think I have used 4 cans. All the MOOG control arms and ball joints have been ordered from Rock Auto. The crossmember and all 4 A arms are going into the HOT TANK tomorrow morning. I really didn't have to use the oven cleaner because it's all going in the HOT TANK...but I wanted to clean it up some, just me.

Alex

This project is officially called and named "PROJECT OVERKILL" read on you will see why! LOL!

05-01-2007, 11:37 AM	#1
ChevyDude Senior Member Join Date: Jun 2003 Location: Westminster, CO Posts: 3,071	Front end tear down Rebuild progress! My newly acquired 71' disc front end was 35+ plus years dirty, of course and has now been completely taken apart and is soaking in Oven cleaner...again. I think I have used 4 cans. All the MOOG control arms and ball joints have been ordered from Rock Auto. The crossmember and all 4 A arms are going into the HOT TANK tomorrow morning. I really didn't have to use the oven cleaner because it's all going in the HOT TANK...but I wanted to clean it up some, just me. Alex This project is officially called and named "PROJECT OVERKILL" read on you will see why! LOL! Attached Images __________________ Alex 1971 Lil' Red 350 SBC 700R4 Last edited by ChevyDude; 05-10-2007 at 11:28 AM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.