|
06-13-2007, 02:50 AM
|
#11 |
|
Registered User
Join Date: Nov 2006
Location: Hollister, CA
Posts: 162
|
Re: My '51 Project
1 off engine mounts
built by by the shop that did my suspension welding He used 1/2 id stock so the the 7/16 " bolts slide in easier. Also made the left side a little thinner on the bottom so the steering will clearance. Transmission (700r4) has a CH clearance and driveshaft is 1/2 " from the rear crossmember when the truck is aired out. Plus the tranny crossmember has some good stock below the pan if we ever go that low. Very pleased with the work he did!
__________________
51 3100 build thread http://67-72chevytrucks.com/vboard/s...light=stevehsd 77 FLH |
|
|
| Bookmarks |
|
|
Threaded Mode