The 1947 - Present Chevrolet & GMC Truck Message Board Network







Register or Log In To remove these advertisements.

Go Back   The 1947 - Present Chevrolet & GMC Truck Message Board Network > 47 - Current classic GM Trucks > The 1967 - 1972 Chevrolet & GMC Pickups Message Board

Web 67-72chevytrucks.com


 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 07-04-2007, 10:41 PM   #1
prg machine
Registered User
 
prg machine's Avatar
 
Join Date: Jun 2007
Location: oregon
Posts: 1,069
Hammer and Dolly lesson??

I have a situation to share and maybe help others out as well as I figure this out, with the members help on this forum of course.

I am in the process of deleting the sidemarkers on a 68 front fender. Both right and left eventualy and the fleet bed as well. To start I chose the right front because it the usual rot at the front corner and also had about 2 quarts of bondo on it from an unexplainable series of dents and wrinkles that cover the whole thing. It looked good when I purchased but alas.......definetly in need of lotsa hammer and dolly etc. The fender is stripped and I have good access front and back. I figure the "bondo bucket repair" was done as a quick fix while the truck it came from was together. I have been guilty of similar " good enough for now " repairs in the past and can't pass blame on to anyone on this.
I ahave done a pretty good job of getting a lot of the dents straight so far and proceeded to delete the side marker. I cut a corresponding piece to fill with and was very careful to get a good fit to remain flush and not have gaps causing pulling and distortion when welded in. I tacked , hammered and cooled with air to not get too hot. As I proceeded the patch wanted to grow up and buckle . I carefuly peened out with hammer/dolly and caught a few more tacks....etc. etc. until all welded. The patch turned out good and fairly flat...........HOWEVER!!!! I now have a hand size concave area about a 1/2 inch deep at the deepest above that patch. It is spread smoothly out and is not straight forward to me how to proceed here. I tried a couple of heat shrink spots at the lowest area, heat a dime size spot red and then chill with compressed air. It seemed to be working.............BUT I stopped because I am now getting other distortion adjacent to the depression. Should I hammer dolly in a particular area?? On or off dolly?? I have no problem with the smaller stuff and even have removed very tight creases at the eyebrow area with only hammer and dolly.
Some wisdom is in order on this one as I feel like I might end up chasing ghosts and end up with another BOBDO Bucket repair. I realy wish to avoid this!!!!
Help????
prg machine is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:51 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com