|
08-07-2007, 12:05 PM
|
#1 |
|
Registered User
Join Date: Aug 2002
Location: Farmers Branch, Tx
Posts: 1,009
|
a/c control levers
I think I got a problem. I ordered new a/c control levers as one of mine is broken. I looked at it last night and am puzzled for what to do. The shaft that the levers rotate around is held in place by a steel plate. This plate is set on two pins which are "hammered" flat to hold it in place. It looks like I need to grind off the pins to remove the plate and then the levers. All is good to this point. The problem is I dont know how I will hold the plate in place after re-assembly. This was much easier on the 68 which has heat only. I know this is probably hard to understand but if anyone does understand and has a solution, let me know. I may try to post a pic later to help explain.
__________________
http://www.picturetrail.com/jwill41 67 1/2 ton GMC short step side 68 1/2 ton Chevy long fleet side 72 1/2 ton Chevy Suburban 99 1/2 ton Chevy Suburban founder (and only member) of the primer/clearcoat club |
|
|
| Bookmarks |
|
|
Threaded Mode