how do i replace steering box? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

low 84 · 12-22-2002, 03:21 AM

okay i wanted to hold off and rebuil the whole frontend this summer but its gotten so bad i can barley keep it on the highway, and the front breaks are shot. so i going to replace, rotors, calipers, pads, wheel bearings, tie rods, and steering box.

so where can i get a GOOD steering box? is there anyone who makes a closer ratio box for our trucks? where is the best place to get one?

and also i have never put a steering box on. is there a tech article somewhere or can someone tell me what all to do. like does it have to be bled to get new fluid in and air out and anything else i need to know?

12-22-2002, 03:21 AM	#1
low 84 Registered User Join Date: Jan 2002 Location: Houston, TX Posts: 2,144	how do i replace steering box? okay i wanted to hold off and rebuil the whole frontend this summer but its gotten so bad i can barley keep it on the highway, and the front breaks are shot. so i going to replace, rotors, calipers, pads, wheel bearings, tie rods, and steering box. so where can i get a GOOD steering box? is there anyone who makes a closer ratio box for our trucks? where is the best place to get one? and also i have never put a steering box on. is there a tech article somewhere or can someone tell me what all to do. like does it have to be bled to get new fluid in and air out and anything else i need to know? __________________ '51 F100, backhalf with a narrowed 9 and coil overs, 18.5" mickeys, monte front clip, +400" sbc in the works '05 1500 Crew Cab RIP '84 swb 5/7 drop, solid cammed 408 w/ fully ported dart heads, th350 w/ 10 inch hughes, 12 bolt w/ 3.73 richmonds and a locker '80 swb 4x4 in progress: 7" lift, 350 th350/np205, d44 and 1.5" ORD tie rod, 14BFF w/discs , armored diff covers, 40" MTR's



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.