holley 600 adjustments? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

75shortysocal · 09-12-2007, 08:40 PM

... truck runs ok..... the holley im using is from ebay...and looks like it hasnt been used in a while.. so when i put it on my motor, it boggs down when secondaries are opened....

i adjusted the 2 side screws, i adjusted the floats.... now it doesnt bog....

but i got on it for about 2 blocks....and burned almost a 1/4 tank...lol so now it doesnt bog........but its burning MASSIVE amounts of gas.....plust the exuast smells really strong now...

and with the accelerator pump......i have no clue how to adjust that...

any thoughts?

09-12-2007, 08:40 PM	#1
75shortysocal 350+dual flows= fun :) Join Date: Oct 2005 Location: TORRANCE ,CA. Posts: 120	holley 600 adjustments? ... truck runs ok..... the holley im using is from ebay...and looks like it hasnt been used in a while.. so when i put it on my motor, it boggs down when secondaries are opened.... i adjusted the 2 side screws, i adjusted the floats.... now it doesnt bog.... but i got on it for about 2 blocks....and burned almost a 1/4 tank...lol so now it doesnt bog........but its burning MASSIVE amounts of gas.....plust the exuast smells really strong now... and with the accelerator pump......i have no clue how to adjust that... any thoughts? __________________ ALWAYS CHECK YOURE FRONT WHEEL BEARINGS!! SPINNING OUT ON THE FREEWAY DUE TO THE BEARING GOING OUT IS PRETTY HAIRY!!! Last edited by 75shortysocal; 09-12-2007 at 08:41 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.