ECE's Cup Holders!

[Rokcrln]

I do not know if this has been covered or not so I did my usual while installing mine. I stopped by ECE last time I was down in Fresno and saw this for the first time and thought it would be a great addition to Low Buck (since I don't smoke).

It was $55 and took all of an hour and a half to install. I do not know if they have these parts made or if they are a factory unit for some other vehical and they just make the mounting plate for our truck. Ether way it is a great piece that is of factory quality noit some flimsy unit like we have all seen before with other parts like this. Their instructions are good but in black and white so I thought while I was at it I would do my own version.

1) First thing is to remove your AC/Heater control panel and then your Ash tray. Mine had 4 screws holding it in but some may be spot welded (according to their directions) and you will need to follow their directions for this.

2) Unpact your parts and you will find every thing you need for the install.

3) You need to drill out the pop rivit that holds on the face of the ash tray.

4) Mark and cut the old mounting lip off as shown and then bend up the two tabs on each end.

Kevin
LFD Inc.