Question About Removing Starter - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Huskerboy2 · 11-06-2007, 05:40 PM

I need to pull the starter on one of my trucks to get it rebuilt. I didn't realizie what a huge pain the starter was to get at. To top it all off, the truck is also sitting on some soft ground, which makes it hard to lift it. So, I'm working a little blind here, somewhat by feel. Can somebody confirm for me what all connections there are holding the starter in. It looks and feels like three connections to the solenoid. One larger plug type connector, which I can't see at all, and two terminal connections. The starter body itself looks like it's held on by two bolts going up through the bottom and a bolt on the front of the starter body that holds it to a support bracket of some type. Does this sound about right?

11-06-2007, 05:40 PM	#1
Huskerboy2 Senior Member Join Date: Feb 2001 Location: Austin, Texas, USA Posts: 1,628	Question About Removing Starter I need to pull the starter on one of my trucks to get it rebuilt. I didn't realizie what a huge pain the starter was to get at. To top it all off, the truck is also sitting on some soft ground, which makes it hard to lift it. So, I'm working a little blind here, somewhat by feel. Can somebody confirm for me what all connections there are holding the starter in. It looks and feels like three connections to the solenoid. One larger plug type connector, which I can't see at all, and two terminal connections. The starter body itself looks like it's held on by two bolts going up through the bottom and a bolt on the front of the starter body that holds it to a support bracket of some type. Does this sound about right? __________________ '72 Chevy Blazer



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.