Gauge question

[geoman]

Guys,

My 67 SWB was an original 6 cyl/3spd "farm truck". I bought it was a 350/400combo. I am going to restore this truck to factory specs on the inside and out, except for the drivetrain.

My gauges are just the big three (speedo to the left, gen and oil pressure lights in the middle, and fuel to the right). I have the wiper switch and headlight switch on the upper left and the choke on the upper right corner. I cannot find a new gauge bezel that replecates this.

I can find the bezel with the 4 smaller holes on the bottom with the switches set up this way but thats it. I have looked at a few of my catalogs and nothing.

I am going to restore the dash and may go with the bezel with the four small holes and put in autometers along the bottom but I was curious about my setup.

Thanks
Mike