Clutch linkage - The 1947 - Present Chevrolet & GMC Truck Message Board Network

prg machine · 11-26-2007, 10:10 PM

I am sorting out a couple of Z bar, clutch arms, and linkages for the 69 K-20. I have 2 Z bars . One is long and the other shorter. i parted a 76 truck and I believe the long one came from that.Not sure. The engine is not in the frame yet and I was wondering if the pre 72 trucks had a narrower frame than the 76.
Also on the end that pushes the throwout arm I have a couple of washers and a 1/2 inch nut on the rod to push against the throwout arm. Definetly back yard . What exactly should the piece look like that goes there, and where can I purchase one?

thanks

11-26-2007, 10:10 PM	#1
prg machine Registered User Join Date: Jun 2007 Location: oregon Posts: 1,069	Clutch linkage I am sorting out a couple of Z bar, clutch arms, and linkages for the 69 K-20. I have 2 Z bars . One is long and the other shorter. i parted a 76 truck and I believe the long one came from that.Not sure. The engine is not in the frame yet and I was wondering if the pre 72 trucks had a narrower frame than the 76. Also on the end that pushes the throwout arm I have a couple of washers and a 1/2 inch nut on the rod to push against the throwout arm. Definetly back yard . What exactly should the piece look like that goes there, and where can I purchase one? thanks



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.