Is this a good price for wood? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jorgensensc · 12-06-2007, 07:24 PM

Hey all,
I think I'm going to try something a little different (yet the same) for the bed floor on the stepper. I went to check and found a Boat repair facility that has a sheet of 4 x 8 x 3/4" Mohagony marine grade plywood he had left over from a boat rebuild. He offered it to me for 125. He also offered me some long mohagony slats to use instead of the metal strips. I planned on securing the bed and then hiding the bolts that go to the crossmembers under the slats and varnishing them a different color. What do y'all think? Is 125.00 for the sheet a good price?
Shawn

12-06-2007, 07:24 PM	#1
jorgensensc Registered User Join Date: Jul 2003 Location: Cypress, Tx Posts: 4,005	Is this a good price for wood? Hey all, I think I'm going to try something a little different (yet the same) for the bed floor on the stepper. I went to check and found a Boat repair facility that has a sheet of 4 x 8 x 3/4" Mohagony marine grade plywood he had left over from a boat rebuild. He offered it to me for 125. He also offered me some long mohagony slats to use instead of the metal strips. I planned on securing the bed and then hiding the bolts that go to the crossmembers under the slats and varnishing them a different color. What do y'all think? Is 125.00 for the sheet a good price? Shawn __________________ 1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.