Replacing Rear bearing & seals on Dana 60 any Tips/Tricks??

[So.Cal.Super]

I was leaving work last night and noticed an oil spot on the ground at my rear tire, when I inspected it closer it looks like the axle seal gave out. I just had changed the rear dif a few weeks earlier and this looked like new oil.

I am going to swing by the auto parts store and order seals and bearings. I figure it is best to do both and both sides at the same time. if memory serves me there should be c clips to remove in the rear to pull the axles out.

anything else I should know or look out for? any special tools besides a really big hammer

thanks.