few more pictures of my build

[56hotrodred]

I managed to get out before the last cold blast of winter hit to get a few more pictures. I have not been able to get anything else done as it turned real cold, like -25 c during the warmest part of the day. It was so cold it froze my battery in my tractor up solid. I was able to bring it inside and re-install and with a boost managed to get the tractor going to dig us out.

Anyway here are a few more shots of how I am planning the front rad supports. They are fabricated from some parts I took off of a 1979 Chev 4 x 4 frame I have sitting out back. The front cab mounts are going to get built up so I can get the rubber spacers down to about an inch in height rather than the the ca. 4 inches that you see in the picture. Not sure if I am going to bolt them in or weld them once I get them built up.

Also threw in a shot of some free grey leather electric seats that work that I was given. I need to lower them a bit but do not want to cut into the floor so will cut down the seat brackets an inch or two. Also have one shot showing approximately how the cab and box will sit with just less than a 4 inch gap.

56hotrodred