|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-09-2008, 04:46 AM
|
#1 |
|
Registered User
Join Date: Aug 2002
Location: Farmers Branch, Tx
Posts: 1,009
|
gage cluster conversion
I just did the idiot light to gage dash conversion per the instructions on GMCPauls website. Everything except the battery gage works and the instructions were easy to follow. I did not run the new wires for pins 1 and 12 because of the following concern. My truck has had the junction block by the battery removed but if I remember it was just a positive wire from the battery. My alternator has also been changed and the12g red wire runs to the positive side of the battery. If I understand the instructions, I will have two positive wires going to the gage. This don’t seem right so I skipped it until I could get verification. Can anyone please confirm or correct my understanding of this. One more question is, what gage wire should I use for the battery gage wires?
__________________
http://www.picturetrail.com/jwill41 67 1/2 ton GMC short step side 68 1/2 ton Chevy long fleet side 72 1/2 ton Chevy Suburban 99 1/2 ton Chevy Suburban founder (and only member) of the primer/clearcoat club |
|
|
| Bookmarks |
|
|
Threaded Mode