|
05-20-2008, 06:20 AM
|
#1 |
|
Registered User
 
Join Date: Jan 2006
Location: Warrington, PA
Posts: 403
|
bell housing?
I recently purchased a 3 speed tranny with a 4 5/8" bearing support. My old bell housing has a larger hole...about 5 1/8". Bolt holes line up fine, but bearing support hole is too large for new tranny. I think I need a new bell housing? If so, any insight on where i can purchase a 4 5/8" bell housing that will accomadate a 11" clutch, or could I still use the old bell housing?
__________________
 69 C10 LWB GM 350 crate motor, 3.73 rearend
Last edited by rick0312; 05-20-2008 at 06:22 AM. |
|
|
| Bookmarks |
|
|
Threaded Mode