wiring harness resistor on a 67 K10 - The 1947 - Present Chevrolet & GMC Truck Message Board Network

killer_mike · 07-21-2008, 11:02 PM

Hey, the engine is on, trannie too, pretty much everything except some body parts. I installed an MSD HEI dist, and the instructions say that i need to remove or by pass the resistor on the engine wiring harness, so where is this thing at?
The engine dont start, it cranks but dont start, theres no fuel getting to the carb what so ever and i changed the fuel pump. I figure out that for some reason if the outlet on the fuel pump is not tight the pump wont pump. The fuel pump is mechanical, Carter.

Thanks in advance.

07-21-2008, 11:02 PM	#1
killer_mike Big Red & Mister Blue... Join Date: Jan 2008 Location: Pat, NJ Posts: 107	wiring harness resistor on a 67 K10 Hey, the engine is on, trannie too, pretty much everything except some body parts. I installed an MSD HEI dist, and the instructions say that i need to remove or by pass the resistor on the engine wiring harness, so where is this thing at? The engine dont start, it cranks but dont start, theres no fuel getting to the carb what so ever and i changed the fuel pump. I figure out that for some reason if the outlet on the fuel pump is not tight the pump wont pump. The fuel pump is mechanical, Carter. Thanks in advance. __________________ K10 1967, SM420 & Rockwell T221 C1500 1991, 305 CID, Ext Cab, Full Size bed, everything original except air cleaner. Last edited by killer_mike; 07-21-2008 at 11:04 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.