69 Cst - The 1947 - Present Chevrolet & GMC Truck Message Board Network

**uncle** · 08-04-2008, 08:22 PM

Going to try it whole first,BUT if parted I will keep the tach and tailgate. Truck would make a decent driver with your engine. truck was 350/4 spd. it has the normal rust ,but has good bed other than some rust in the rear and the floor brace where the gas tank mounts. Header panel and tubs are nice. Interior is pretty clean w/good door panels and seat belts. Tailgate is rustfree (other than surface) ,but has a few small dings inside and one on the d/s rear. $800 for the whole truck. I figure the tach and gate are at least $400,so you do the math. Please respond to post. NOW PARTING!!!!!!!!

08-04-2008, 08:22 PM	#1
uncle Senior Member Join Date: Aug 2003 Location: Conyers,Ga. Posts: 7,288	69 Cst Going to try it whole first,BUT if parted I will keep the tach and tailgate. Truck would make a decent driver with your engine. truck was 350/4 spd. it has the normal rust ,but has good bed other than some rust in the rear and the floor brace where the gas tank mounts. Header panel and tubs are nice. Interior is pretty clean w/good door panels and seat belts. Tailgate is rustfree (other than surface) ,but has a few small dings inside and one on the d/s rear. $800 for the whole truck. I figure the tach and gate are at least $400,so you do the math. Please respond to post. NOW PARTING!!!!!!!! Attached Images Last edited by uncle; 08-11-2008 at 04:00 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.