![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Jul 2003
Location: Cypress, Tx
Posts: 4,005
|
Baggin' the new Burb Question.
My wife wants me to bag the burb, so that she can get in and out easier. It is a 3/4 ton Big Block '72, with coil rear end. I have an compressor setup from Arnot that I was going to use in my truck, 2 valves,1 dual needle gauge, with 2- 6" bags from Slam Specialties. I was setting it up in my truck so either back bag could be aired individually for load leveling, etc. My questions are:
1) I know everyone is saying the 7" and 8" bags are better for the rear of the trucks. But can I use my 6" bags for the front of the burb? 2) If I get 7" bags for the rear, will that be enough? Or should I get 8" bags for the rear? 3) Will the cups and plates for the front a-arms on a 1/2 ton work on the front A-Arms on the 3/4 ton? There are some on the parts board I may get if they will work correctly. 4) Do I need to get drop spindles? We are not looking for a crazy drop, but the burb is way too high for her right now. If so, Do they make 3/4 ton drop spindles? Who sells them? Thanks for all the help guys!! SHawn
__________________
1972 C20 Suburban- Big Blue Betty '56 Chevy Bel Air Sedan- Frame up Restoration -What would you attempt to achieve if you knew you could not fail?- -I Refuse To Tiptoe Through Life, Only To Arrive Safely At Death's Door- R.I.P. EAST SIDE LOW LIFE |
![]() |
![]() |
Bookmarks |
|
|