|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
09-10-2008, 01:59 PM
|
#1 |
|
Restoring it $200 at a time...
Join Date: Aug 2008
Location: NE Kansas
Posts: 889
|
Flaky oil press gauge /circuit
Until yesterday, it read 3/4 scale hot on the road and 1/4 scale at idle. Now I'm seeing 1/2-3/4 scale at idle and 3/4 to full scale when driving. RPMs don't matter much. Oil level is good and the needle does drop down with power off.
1. Do I blame the printed circuit or the gauge itself? 2. Can I run a printed circuit for a tach dash w/o the tach (until I get that upgrade done)? Thanks.
__________________
Charter member of the 'Put the dimmer switch back on the damn floor where it belongs' Society '68 5.3L-4 speed LWB C20; grandpa bought it for the farm in '71. Now LS 5.3, rather than 327. DD '09 Pilot Weekender '65 Skylark 300-4V-4 speed Wife's '07 Lexus ES350; 117 actuator motors and I can't see the engine. Son's '04 F250 SuperCab 6.0 |
|
|
| Bookmarks |
|
|
Threaded Mode