Inline tube trans lines/ bent wrong? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Sport/Truck · 11-03-2008, 10:18 PM

I ordered some inline tube trans cooler lines and tried to install them. They don't look quite right to me.
I called them and mentioned about the shipping bend. Cameron said "we don't put shipping bends on transmission lines". They sent them to me like that.

So I straightened the bend out per their instructions and it seems close.
the lower line was shipped just like it is, and it seem short!

I have the upper line hooked to the top of the hole on the transmission, and the lower line to the lower hole. Is this correct?
anyone else have problems with inline tube?
s/t

11-03-2008, 10:18 PM	#1
Sport/Truck Sierra Grande Club Join Date: Jan 2007 Location: New Mexico USA Posts: 2,433	Inline tube trans lines/ bent wrong? I ordered some inline tube trans cooler lines and tried to install them. They don't look quite right to me. I called them and mentioned about the shipping bend. Cameron said "we don't put shipping bends on transmission lines". They sent them to me like that. So I straightened the bend out per their instructions and it seems close. the lower line was shipped just like it is, and it seem short! I have the upper line hooked to the top of the hole on the transmission, and the lower line to the lower hole. Is this correct? anyone else have problems with inline tube? s/t Attached Images __________________ 1971 GMC Sierra Grande, 1/2 ton short wide, original 4 bolt 010 020 block & heads. (matching #'s). 383 stroker, SMI q jet 750 cfm, Lunati Voodoo 60102 cam, Scorpion roller rockers, Spin Tech pro street mufflers with X pipe.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.