Im at my wits end here with door alignment.

[lyrikz]

Im really at my end here. This door is goign to be the damn DEATH of me...

I can NOT get it to align. The top upper left corner touches and the upper right where it curves down is sitting about 3/4 of an inch to low.

My questions are this.
Can that door frame be bent? Can i remove the spot welds at the bottom right corner of the post and pull the post up a bit and reweld it???

ANY tips to getting the door to align would be appreciated.. here is another pic... Also, the hinges were pretty bad so i replaced them. Nice and firm now.