converting to power rack and pinion? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

daveodom · 11-11-2008, 11:58 PM

I'm in the process of bagging my 64' c-10. I have already z'd the front clip 4" and the rear 10". I have also moved the engine/tranny back about 10". My question is: I was wanting to convert to a power rack and pinion set-up. What is the rack that I want? Mustang II? What is the rack that Porter uses? Anyone done this with the stock crossmember? Also I have narrowed my control arms 1 1/2" on each side and moved the ball joint forward 1" to center the wheel in the wheel well. Thanks for any info/pics.

Dave

11-11-2008, 11:58 PM	#1
daveodom Registered User Join Date: Feb 2008 Location: Ozark, Missouri Posts: 83	converting to power rack and pinion? I'm in the process of bagging my 64' c-10. I have already z'd the front clip 4" and the rear 10". I have also moved the engine/tranny back about 10". My question is: I was wanting to convert to a power rack and pinion set-up. What is the rack that I want? Mustang II? What is the rack that Porter uses? Anyone done this with the stock crossmember? Also I have narrowed my control arms 1 1/2" on each side and moved the ball joint forward 1" to center the wheel in the wheel well. Thanks for any info/pics. Dave Attached Images



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.