'71 Bed + half frame, doors, 68 cab, 69-72 fenders, more...

[menlatin]

Got some parts that i never got a chance to put on my truck before i moved to San Antonio.

Some of the parts are in San Antonio, some in Denton.

Bed + frame + 12 bolt from a front end wrecked '71.
I'd say its in pretty good condition aside from a little surface rust and 2 or 3 small dents. There's also an indication on the left side where, during the accident, it skimmed by something.

The tailgate is in very good condition with only 1 tiny dent which could probably be easily popped out. The trim and lights are PERFECT on the rear. one of the side lamps is missing though. We cut the frame just in front of the cab mounts and every thing from there back is still attached. One of the axles in the 12 bolt is broken though. I'm sure it can still roll on to a trailer though. The wheels will also be swapped to a less aesthetically please set.

Asking $600 for all of it. Come take a look at it and see what u think. I've only got a few pictures. This is in Denton, TX



'68 Cab. Has some rust at the fire wall. I think my brother is removing the fuse box and associated wiring, but that may be able to be negotiated. The fenders are not included.

Asking $200. This is in Denton, TX


Passanger and driver side doors. Glass is all good, and they function ok. They could probably use a cleaning though since they have been outside. no dents, and both doors cut for 6x9 speakers. There is some rust at the bottom of the doors. Latches and handles function fine, but we don't have the key to the locks. All the trim is good on the doors as well.

Asking $250. These are in Denton, TX


69-72 Left and right finders. don't have a picture of these, but they are resting inside the above cab. Got them at a swap meet for $50 each in decent condition. Sorry no picture of them, but u can see them from the cab pictures.

Asking $75 for the pair. These are in Denton, TX


'71 Grill. Has a couple small cracks, and some damage around the aluminum.

Asking $50. This is in Denton, TX


Diamond plate tool box. Removed it for weight reduction. No dents, and my brother has since cleaned it up.

Asking $80. This is in Denton, TX


Crane solider roller lifters + (i think) 40lb rev kit for SBC. Has one bad roller, but i bought another one from a machine shop, just never swapped it on. So there's actually 17 lifters. All the others spin fine.

Asking $150. This is in San Antonio, TX


Mallory billet points distributor + Mallory coil + Mallory ignition box + 8mm wires. Never got to install this, although i did install the ignition box with my HEI setup.
SOLD


Aftermarket front sway bar. looks like grade 8 steel or whatever. Its all goldish colored. I don't have the hardware though it got lost somewhere in the move. The sway bar is REALLY heavy duty and much thicker than the stock sway bars. I could not use it because i used drop springs in the front instead of spindles.

Asking $50. This is in San Antonio, TX



Well that's all i got. Prices are somewhat negotiable, but please, not blatant low-balling.

I"ll probably respond to emails faster so aari13@gmail.com

You can also email me for more pics.