Painless Wiring and Welder Series Gen III parts - The 1947 - Present Chevrolet & GMC Truck Message Board Network

jkaylor68gmc · 11-25-2008, 03:03 PM

http://www.welderseries.com/

Got a set of LS-mounts to put a 4.8 in my '47 IH (sitting on a 65 C-10 frame) and they were awesome. I used my truck mounts, had to trim them a little but did retain the truck mounts, they costs 60.00 for the set and worked and looked great! A+ service also.

Purchased a Painless 4.8/5.3/6.0 harness and it was the best wiring harness I have ever installed! Great instructions, took about two hours to complete!
Plus, since I got the harness, they flash te Vats and EGR stuff out for free!

TWO GREAT COMPANIES TO WORK WITH. A+ Money well spent!

11-25-2008, 03:03 PM	#1
jkaylor68gmc Senior Member Join Date: Dec 2005 Location: TN Posts: 2,448	Painless Wiring and Welder Series Gen III parts http://www.welderseries.com/ Got a set of LS-mounts to put a 4.8 in my '47 IH (sitting on a 65 C-10 frame) and they were awesome. I used my truck mounts, had to trim them a little but did retain the truck mounts, they costs 60.00 for the set and worked and looked great! A+ service also. Purchased a Painless 4.8/5.3/6.0 harness and it was the best wiring harness I have ever installed! Great instructions, took about two hours to complete! Plus, since I got the harness, they flash te Vats and EGR stuff out for free! TWO GREAT COMPANIES TO WORK WITH. A+ Money well spent! __________________ 1947 International KB-1 1957 Chevy Bel-Air riding low 1962 swb fleetside 2002 Chevrolet Silverado 7-inch lift on 35 Daily driver 2016 Chevy Tahoe Better halves ride



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.