12-03-2008, 12:22 AM | #1 |
Registered User
Join Date: Oct 2008
Location: Auburn, Ca.
Posts: 171
|
Front end
I have a 80' front end that I am using to update my 63' I am planning on just using the arms and spindles, not the crossmember. My question is.....what is the best way to remove them from the crossmember. I have read up on the method of putting a jack under and backing the castle nuts to almost off then wacking it with the pickle fork and then allow the weight of the engine etc. to safely release the energy of the spring as you lower the jack. However, since mine is out of the truck already and I dont have the weight of the engine, what are my options?
Thanks for helping with a beat up subject. |
Bookmarks |
|
|