Just how bad can a repop outer rocker be?

[KrazyKevin]

Got my cab corner in place. The alignment is pretty good by looking at the back of the cab. Now where the cab corner rolls into the B pillar and rocker area I did have to do some slicing because it was about 1/4" past the B pillar where they should mate. My door alignment in my eyes is ok. The clearances look pretty darn good. But with that said, my outer rock I bought from Summit (Goodmark) is not cooporating at all. With the rocker set in place, it is about 1" off from the B pillar. Also, everyone on the board says that the top ridge of the oute rocker should be about 1/4" below the floor. Well my outer rocker is sitting as low as it can go. It can't go any lower unless I start beating the cab floor down. The rocker is sitting on the lip of the cab floor. I think my cab floor piece is good. Can a outer rocker just be this screwed up? I understand that I'm probably off a little here and there, but this thing is just really giving me a time.