Engine Build

[JW76]

Sorry for such a long complicated question but you answered my last post so well.

I am looking to build a motor out of spare parts. This is what I am thinking of using: I have a 350 block bored 30 over, speed pro pistons flat tops with 4 valve reliefs, standard factory rods and crank. I have a weiand stealth intake (dual plane) a holley 650 double pumper carb. The cam I have is 470 470 lift 224 224 duration w/ LSA 114 degrees. The heads I am thinking of using are World S/Rs with 1.94 1.50 valves and 76 cc combustion chambers .550 lift springs and 1.5 roller rockers. The compression ratio I came up with is 8.75 - 9ish. I am going to run this with a 1800 stall or 2500 stall converter, turbo 400 with manual valve body, and a 276 rear gear ratio. Will this combination work well? Any idea what horse and torque I might push? Lastly, is the CR too low?

Thanks for your help