dana 60 hub locks - The 1947 - Present Chevrolet & GMC Truck Message Board Network

mudmizer · 01-16-2009, 01:40 AM

Anyone know how to get these hubs apart? Is there a C type clip or some sort of retainer holding these together by where my screwdriver is pointing? I can't see anything and I don't want to break the threaded dial. I want to clean them up and gently blast them clean of paint but I want them apart so I can get all the sand out of them.
Second question is why are my old Dana 44 hubs bigger than the new Dana 60? Wish I could use the old heavy dials.
The 60 came from a CUCV.

Thanks
Bob

01-16-2009, 01:40 AM	#1
mudmizer Registered User Join Date: Jan 2007 Location: Bellingham, washington Posts: 260	dana 60 hub locks Anyone know how to get these hubs apart? Is there a C type clip or some sort of retainer holding these together by where my screwdriver is pointing? I can't see anything and I don't want to break the threaded dial. I want to clean them up and gently blast them clean of paint but I want them apart so I can get all the sand out of them. Second question is why are my old Dana 44 hubs bigger than the new Dana 60? Wish I could use the old heavy dials. The 60 came from a CUCV. Thanks Bob Attached Images __________________ 68 4x4, 454, 4 speed, disk brakes both ends, Sold my 69 SS396 Elcamino when young & stupid



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.