|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
03-08-2009, 10:16 AM
|
#1 |
|
Senior Member
 
Join Date: May 2006
Location: Philadelphia, Pa. 19454
Posts: 9,774
|
Need Help M/C demensions- Disc/Drum
I've read a thread on here where it was stated that the front chamber of the M/C is larger then the rear. It makes sense as the capacity would need to be more as the pads wear, and the bore is larger on the disc than the wheel cylinder. I don't doubt this, but my chambers are the same size.
When I bought the new M/C I held them side by side and everything looked the same, that does not mean that the PO didn't change it before me...so, my question is this, can someone verify the actual demension of the front chamber of a M/C with a disc/drum setup from a '72. I don't want to go back to the supply house without some sort of ammo. Thank You for anyone taking the time to help me out...  
__________________
Semper Fi...Uncle Sam, you da man All parts offered to help are free, unless otherwise noted Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training SAFETY FIRST AS usual, off topic They say your mind goes second, can't remember the first Jim |
|
|
| Bookmarks |
|
|
Threaded Mode