1-tonmudders 241/205 Doubler

[1-tonmudder]

Ok so after a short hiatus I finally got back on this today.Pulled the old 400/205 out.


Since I went to a 241 case it requires a different lenth output shaft in the 400.Their are 3 different lenth's on the 400 output's and it depends on what case your runnin.They are as follows.
NP203
NP205-figure eight or racetrack pattern with the short input
NP-205,208,241-round pattern with the long input.
Since I had to change the output shaft and the 400 I was running had a ear broke off of it I elected to just completely replace the trans.I had a good lo-mileage 400 from a CUCV that originally had a 208 behind it so the 241 will be a direct bolt in.

Got the trans in and all buttoned up and started assmebling the 241.


Not a lot of progress for 8 hours work but considering all the distractions I done pretty good.

I also got these in last week.