Heim rod ends to replace stock tie-rod ends? - The 1947 - Present Chevrolet & GMC Truck Message Board Network

MXmaniac · 03-24-2009, 05:58 PM

I'm thinking about using heim rod-ends in place of the stock type tie-rod ends so that I can attach them on the underside of the stock mounting point on the spindle. I'm going to be using 1-1/2" stepped LCAs and 3" drop springs so it seems like using heims on the underside would be a good way to help lessen the angle of the tie-rods and keep them more level. So far my plan is to drill out the tapered hole to 5/8", and use a heim with a 5/8" bore and bolt it together with some grade-8 hardware. Has anyone done this? What are the pros and cons? This is common on race cars, correct?

03-24-2009, 05:58 PM	#1
MXmaniac Registered User Join Date: Jan 2007 Location: Independence, OR Posts: 356	Heim rod ends to replace stock tie-rod ends? I'm thinking about using heim rod-ends in place of the stock type tie-rod ends so that I can attach them on the underside of the stock mounting point on the spindle. I'm going to be using 1-1/2" stepped LCAs and 3" drop springs so it seems like using heims on the underside would be a good way to help lessen the angle of the tie-rods and keep them more level. So far my plan is to drill out the tapered hole to 5/8", and use a heim with a 5/8" bore and bolt it together with some grade-8 hardware. Has anyone done this? What are the pros and cons? This is common on race cars, correct? __________________ 1969 C20: 292 L6, SM465 4-speed, Eaton HO52 4.56



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.