![]() |
Register or Log In To remove these advertisements. |
|
|
|
Thread Tools | Display Modes |
![]() |
#1 |
Registered User
Join Date: Feb 2006
Location: Smyrna, Ga
Posts: 1,647
|
Pulleys....Billet or stamped?
I recently replaced my steel pulleys (water pump and crank) with billet pulleys as well as replaced the water pump and balancer.
before, the steel pulleys had alittle wobble to them and my thinking was that the billet would be truer than the steel since they are machined. after the install the billet water pump pulley, especially, is worse than before. How much wobble are you guys seeing in your pulleys? can you noticably see they are not true or are they pretty true? i was going to put an indicator on there to see if i could measure the wobble. i am wondering if the water pump shaft is bent or if the flange that the pulley and fan mounts too isn't square. before i rip it all back off i would like to know if this is normal. |
![]() |
![]() |
Bookmarks |
|
|