|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
04-19-2009, 06:02 PM
|
#1 |
|
Registered User
Join Date: Jun 2007
Location: oregon
Posts: 1,069
|
Eaton Rear axle Spindles
I am pulling parts off of an old Eaton rear axle that I aquired for the 4:10 3rd member a few years ago so it is time to clean house. I decided to save the axle shafts and drums and got the drum off of one side............it was brutle!!! Shoes rusted to drum making it near impossible to remove, some clever prybar work, penetrating oil etc. and I got the one side off to save the hub and drum assembly.
I rattled the 4 bolts off that hold the backing plate and I thought spindle on. Does the spindle come off of the axle housing?? Is it machined in place?? Some moderate persuasion didn't move anything so I thought it best to inquire....................anyone know for sure???
__________________
69 K-20 cloned to a 67 with front clip and some other stuff. 383 .040 over Crane roller cam lifters and rockers ,1.6 intake ratio, Open chamber heads, 9.5-1 compression ratio, 2.02 intake valves , Edelbrock performer Air Gap manifold Carter AFB performer 750cfm, MSD ignition, SM465 NP205 4.10 gears: 
|
|
|
| Bookmarks |
|
|
Threaded Mode