Two-piece drive shaft phasing

[gcburdic]

Hey Guys,

I wanted to bring this back to the top, and don't mean to hi-jack this thread, but I think it applies?!?!?
I stopped by the shop that balanced the driveshaft and installed the carrier bearing....he looked at it again and said that he knew it was 1/4 turn out, but said that is how some of them came from the factory?!?!....
I really didn't notice any vibrations while driving it home, but I can't say there isn't one.....ugh....should I take it to another shop and get it in phase, or should it be okay??

Thanks for any input!!!