|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
05-30-2009, 07:38 PM
|
#1 |
|
Senior Member
Join Date: Jul 2001
Location: Muskegon,MI,USA
Posts: 6,026
|
Outer bearing seized to spindle question
I am trying to disassemble a front axle on a 71 K-10 and on one side the inner race of the outer bearing is stuck or frozen to the spindle. The bearing had failed for lack of grease and has been very hot when it seized on the spindle.
I am a little hesitant to apply a torch to the bearing because of the "kickback" from blowing into a hole. Any tips on how to remove the bearing so that the rotor can be removed would be appreciated. Jim
__________________
1971 Shortbox step side 4x4, 350 sbc, 3:07 rear end 1965 Impala SS 400 sbc, Muncie rock crusher 1966 Impala SS 396 bbc, TH 400 1969 El Camino, 350 sbc, TH 350 1971 Snowplow built on a Blazer frame 1972 GMC Short bed, stepside, TH 400, 427 BBC |
|
|
| Bookmarks |
|
|
Threaded Mode