|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
06-14-2009, 07:36 PM
|
#1 |
|
Registered User
 
Join Date: Aug 2008
Location: Central TX
Posts: 393
|
Front wheel bearing seal question
Installing new front wheel bearings and installed the seal. Once installed the seal is not flush with the hub and sticks up about 1/16". I checked the part # (National 9015S) and it is the correct seal for my truck which is a 69 C10. I have installed seals on several vehicles and always tapped them in until they were flush. Any ideas what is wrong here or are they supposed to stick up a bit?
|
|
|
| Bookmarks |
|
|
Threaded Mode