motor mount and manual bell housing position ques???

[ozman3803]

Ok I have a 70 swb 2 wheel drive. I assuming that it had a inline 6 with the muncie 4 spd. I have been having troubles finding the clutch linkage assembly. I finally found the linkages out of a 70 3/4ton that is two wheel drive. I was in a hurry and forgot to ck out where the postion of eng and bell housing were. It did have a two piece driveshaft though I noticed. Of course I put it in today and it is still coming up short to the shift fork. It's about 4 in short or so, looks like it might have to move the bell housing up to next holes (if thats correct?). If that is the case, looks like a new drive shaft if going to be needed. What is going on here, anybody have an answer for me or even better some pictures. Sorry I don't have any pics, but if needed maybe I can get some loaded up from my phone this week. Eng mounts are in the rear position currently.