I don't seem to have a PCV...

[Gibson]

I suppose I could be stupid or blind - but I can't find it anywhere. I know the PO did a lot of the work himself, so he might have done something incorrectly. I'm assuming I NEED to make sure it gets added back in if it is gone. Can you guys point me in the right direction?

Here is where I expected to find it:


or here...


Or anywhere in here:


Argh! I need to find a full vacuum diagram for my engine, but I haven't even had any luck with that (many great topics here on the forums on it - I'm just not sure which 350 permutation I have - and the Edelbrock isn't helping). But I can't even find my engine number. I'm beginning to fear it has been machined off.

Isn't this where it is supposed to be?


The only number I found was on the bell housing, and it just read "D1473" which as far as I can tell isn't even a correct casting number.

Any help is appreciated, even if it turns out I'm a moron
Thanks!