![]() |
![]() |
#19 |
Registered User
Join Date: Mar 2001
Location: Paradise TX USA
Posts: 1,200
|
I'm using 3/16 inch mild steel rod in that pic, but 1/16 works better for thin sheet metal.
The Henrob operates at only 4 psi on the gas and 02 so you get a soft concentrated flame that is hotter and much more controllable than with a conventional type of torch. You can still get some distortion if you stay in one place too long, but with a little practice, you can make some really clean welds. I've had good results with it so far. Ck out their website for some online demos and more info: http://www.cut-like-plasma.com/
__________________
"Negative people always seem to have a problem for every solution" Last edited by Eddie H.; 04-04-2003 at 11:22 PM. |
![]() |
![]() |
Bookmarks |
|
|