|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
08-19-2009, 05:19 PM
|
#1 |
|
The oddest Todd around
Join Date: May 2004
Location: Miami, Florida
Posts: 1,418
|
Pull tranny... or not to pull tranny... that is the question
So...
I already know I'm pulling the motor to replace it.     It is a 350 in a 72 c-10. Now... do I pull the th350 tranny at the same time... or just disconnect the tranny and leave it in the truck? I'm sooooooooooo on the fence about this. I'm going to be doing this all in my driveway, and I'm trying to do the LEAST amount of work possible when it come to pulling and sticking this thing... So... leaving it in the truck, I unbolt the torque converter and the bell housing yes? Kick down cable and... vacuum line??? yes??? Pulling the tranny means unhooking trans cooler lines, speedo cable, and... linkage... uhh... driveshaft and tranny mount...   yes???
__________________
"The greatest pleasure is to vanquish your enemies and chase them before you, to rob them of their wealth and see those dear to them bathed in tears, to ride their horses and clasp to your bosom their wives and daughters." Ghengis Khan IIOY??? Last edited by toddtheodd; 08-19-2009 at 05:20 PM. |
|
|
| Bookmarks |
|
|
Threaded Mode