suggestions on fuel line fitment

[vegaschevy]

I have this new carb i am finally getting around to installing. The fuel inlet is a dual feed set up and the supplied bracket hits the AC bracketry.
I see one of a couple fixes.
A. Put a carb spacer under the carb which may work and provide enough clearance.
B. bend the fuel line a bit which would give it a 45* bend and clear the bracket. (seems like the best)
C. find a flexible fuel line.

If I go with B is their a tubing bender small enough to fit in the available short arm to bend it out accurately on both arms?
DoeS anyone else have a suggestion?