slider bar/ additional jack point

[dammitmitchell]

hey gents, nearing the end of my project here and now it's getting to time for the rocker pannel repair
i was wondering
has anyone or does anyone have a reccomendation for running some square tubing below my rockers for a slider bar or a additional lift point?

got any ideas?
i was thinking two or three inch square tube, then i can run the supports to the frame and bolt/weld them to the frame

wanting to do this the same time i make an "X" for my rear frame
i'll be putting a trailer hitch in (just bolt on) but then boxing the frame near it with pretty much a large "X" so while im tugging folks out of the mud i quit twisting parts back there...


thanks for inputs... and pictures are even better!