what carb should i use... - The 1947 - Present Chevrolet & GMC Truck Message Board Network

bitchin85 · 09-29-2009, 09:48 PM

my truck has a rebuilt 355 with mild cam high compression heads and an edelbrock open throat intake with a 3 inth spacer on it. ( my redneck version of A highrise haha) i have a 1406 edelbrock 600cfm on it now and it runs really ritch. the carbs only 2 years old but it sat with gas in it on my project car. i have the air fuel screews turned out 1 1/2 turns and the choke is set right. someone told me it could be gummed up and a float or somethings stuck inside causing it to run rich. i also have a freshly rebuilt 500 cfm edelbrock sittin on my bench. will this be enough for my motor or should i tear my 600 apart and find the problem? thanks

09-29-2009, 09:48 PM	#1
bitchin85 Registered User Join Date: Aug 2009 Location: Lambertville MI Posts: 962	what carb should i use... my truck has a rebuilt 355 with mild cam high compression heads and an edelbrock open throat intake with a 3 inth spacer on it. ( my redneck version of A highrise haha) i have a 1406 edelbrock 600cfm on it now and it runs really ritch. the carbs only 2 years old but it sat with gas in it on my project car. i have the air fuel screews turned out 1 1/2 turns and the choke is set right. someone told me it could be gummed up and a float or somethings stuck inside causing it to run rich. i also have a freshly rebuilt 500 cfm edelbrock sittin on my bench. will this be enough for my motor or should i tear my 600 apart and find the problem? thanks __________________ "I'll keep my guns, money, and freedom. You can keep the "change"



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.