TX Selling one project to make room for the other

[jholley]

I have a complete rolling 69 SWB chassis with a TON of work done on it that I'm going to sell to make room for my 72 I just got not long ago. I'd like to sell the chassis whole but if there isn't any interest I'll probably part it out at a later date. Here is a list of parts and what has been done.

The chassis was stripped, c-notched (weld in), primed and powdercoated. All of the suspension pieces, front and rear were stripped and powdercoated.

Parts, starting at the front...

Front Crossmember is new
New POL Tubular SB motor mounts
All new ball joints/tie rod ends
New cross shafts upper and lower
ECE 2.5" drop spindles
New front rotors
New front calipers (5 lug)
New wheel bearings/seals
New CPP tubular trans crossmember
New ECE drop center crossmember
New trailing arm bushings
New rear shock relocators
New CPP 2" drop blocks
New KYB Shocks all around 2/4 drop
New CPP 2" drop springs (front)
New CPP 4" drop springs (rear)
New CPP C-notches
New custom built driveshaft
New POL 19 gallon baffled aluminum fuel tank w/sender
New CPP curved panhard bar
New rear crossmember
3.07 Posi rear end w/disc brakes (5 lug) cleaned/painted
New Glocks rear caliper mounts
New rear impala rotors
Rear camaro calipers
Steering Box
1 1/8 front sway bar

All of the parts and powdercoating cost alone total up to better than $3700. I can e-mail a list of what I paid for all this stuff if anyone is interested. That $3700 doesn't figure in any labor or shipping costs either.

I'd like to get $3000 for it.

This is a quality piece that will save somebody a ton of time on their project. All of the hard work is already done. Run some plumbing on it and put a body and a motor on it and your done. I'll include a set of wheels and tires to roll it around with. Oh and I can provide a good title and cab VIN plates with it too.