|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-06-2009, 06:57 AM
|
#1 |
|
Jonny
Join Date: Apr 2008
Location: Outside the Box, Austin,TX
Posts: 741
|
C2500 upper ball joint into a C20 UCA?
I was wondering if anyone knows if a upper ball joint from a 88-98 C2500HD or C3500 will bolt into the upper control on my 83 C20. I am exploring ways to lift my truck and would like to put lift spindles on it. I know I could use a C2500 light duty spindle, but then I would be swapping to 6 lug and I don't want to loose my 14 bolt ff rear as I don't think a 12 bolt will stand up to the power of the cummins that's in the truck. I've already grenaded 2 14 bolt semi floating axles in this truck and I would think they were stronger than the 12 bolt, but correct me if I'm wrong.
Edit: I've already found out the lower ball joint will fit the lower control arm. I'm also wondering if the 8 lug rotor might fit on the 6 lug spindle?
__________________
1966 C30, Cummins, stacks, and a flat bed in progress... "Honor.....simply put, A veteran - whether active duty, retired, national guard or reserve is someone who, at one time in his life, wrote a blank check made payable to 'The United States of America', for an amount of 'up to and including his life.' That is Honor, and there are way too many people in this country who no longer understand it." -AEC Hundley USNR Last edited by sailed2japan; 11-06-2009 at 06:58 AM. Reason: More info |
|
|
| Bookmarks |
|
|
Threaded Mode