Today's Project - The 1947 - Present Chevrolet & GMC Truck Message Board Network

Sinister · 11-09-2009, 04:52 PM

Threw my power steering belt on the freeway doing 70 mph. Fun.
Went to put a new belt on and discovered the bracket was broken and one of the bolts was broken off in the engine block. Welded a nut to the broken bolt, welded the bracket back together. (Luckily broken piece was held on by a nut on the pump.

) Waiting for the girlfriend to get back so I can go to the hardware store and finish up. Does the bracket look right? I had closed up the piece I welded with some new metal, but I cut it back out because it didn't look like the pump would go into the bracket closed up. Also anybody know what size the little bolt is that goes in the front of the bracket and pump? Bolt would go in the hole on the bottom right, front of pump. 350 SBC.

11-09-2009, 04:52 PM	#1
Sinister Between Trucks... Join Date: Mar 2002 Location: Los Angeles, CA. Posts: 3,830	Today's Project Threw my power steering belt on the freeway doing 70 mph. Fun. Went to put a new belt on and discovered the bracket was broken and one of the bolts was broken off in the engine block. Welded a nut to the broken bolt, welded the bracket back together. (Luckily broken piece was held on by a nut on the pump. ) Waiting for the girlfriend to get back so I can go to the hardware store and finish up. Does the bracket look right? I had closed up the piece I welded with some new metal, but I cut it back out because it didn't look like the pump would go into the bracket closed up. Also anybody know what size the little bolt is that goes in the front of the bracket and pump? Bolt would go in the hole on the bottom right, front of pump. 350 SBC. __________________ Beat it to fit, Paint it to match... Last edited by Sinister; 11-09-2009 at 05:16 PM.



Register or Log In To remove these advertisements.

Register or Log In To remove these advertisements.