Laying frame my way, with your help.

[butterboy]

Hey guys long time forum watcher first time poster..I figured it's time. I just bought a new used plasma cutter(thermal dynamics) and need a good project to really use it. So with my stick welder in one hand and my plasma torch in the other I want to lay out the frame on my 70 c-10. Here is a quick run down of my truck. In the front I have three inch drop coils with 1-1/2 coils cut off of them and a disc brake convert. In the rear I have leaf springs, so I flipped my axle over the wore out leafs and did a 3 inch c-notch...So now my truck sits 9 inches off the ground. Now here is my thoughts for the front is to z my frame 3 inches and buy 73-87 3 inch drop spindles and bags to bring the front down to the ground...Now the rear...I have a 67 shortbed rolling frame with factory coils in the back. So was thinking about z-ing the rear 5 inches just after the back of the cab then bolting bags in place of the coils, adding a big c-notch and calling it a day. If your still reading this thanks..Here is a picture of my truck now.