|
Register or Log In To remove these advertisements. |
|
|
|
|||||||
|
|
Thread Tools | Display Modes |
11-30-2009, 10:30 PM
|
#1 |
|
Registered User
Join Date: Apr 2009
Location: Centreville, Virginia
Posts: 846
|
Bucket Seat Install on Suburban tracks in Std. cab
I know this might have been covered before but, has anybody installed bucket seats in a std. cab on Suburban tracks? My hole setup came out of an 80' Suburban. I knew I was going to have to drill out the (2) rear passenger holes as well as the inside driver's side hole but, the mounting tabs don't even come close to being flush with the floor on the rear shelf. Are you guys fabricating brackets of some kind???????
__________________
The Fleet........ 68' Camaro - 1st car (restored & still have it) 09' VW Tiguan (Wife's Daily Driver) 14' VW Passat SE TSI (my personal) 14' Ford Edge Sport (Daily Work Vehicle) 73' SWB Stepside - 77K org. miles 74' LWB 454/TH400 - drive train transplant for my (Sold) 98' SWB C1500 W/T - shop truck (Sold) 90' GMC Sierra SLE short step - aka " Jezabelle " (Sold) |
|
|
| Bookmarks |
|
|
Threaded Mode